Short answer: Keep everyone clear of the damaged section, take photos before anything is moved, and check the board the eavestrough was hanging from. If that wood is soft or dark, the real problem is rot behind it, and replacing the eavestrough alone won't hold.
Why eavestroughs come down
Eavestroughs rarely fail out of nowhere. Most come down for one of three reasons:
Heavy, wet snow and ice. A run full of ice is far heavier than it was built to carry.
Old sectional eavestroughs. Every joint is a weak point. Over time, the seams separate and the hangers loosen.
Rotted fascia. The eavestrough is only as strong as the board it's fastened to. When that board softens, the screws pull out under the first real load.
Wind usually finishes the job. It catches a section that was already loose and peels it off.
What to do first
Keep people, pets and vehicles out from under it. A hanging section can drop without warning, especially with ice still in it.
Take photos from the ground. Get the damaged run, where it pulled away and the wall underneath. Your insurer may want them, and they help us quote accurately.
Don't climb up to force it back. Snapping a bent section back into place usually cracks it, and ladders on icy ground are how people get hurt.
Look at the board behind it. From the ground, check the fascia where the eavestrough was attached. Dark, crumbling or soft-looking wood means rot.
Watch where the water goes. Without eavestroughs, roof water lands right at your foundation. If you can, direct it away until it's fixed.
Repair or replace?
If one short section came down on an otherwise solid system, a repair can make sense. If the system is old, sectional or came down because the fascia behind it rotted, replacing it is usually cheaper in the long run than repairing it twice.
Why it matters in Simcoe County, Muskoka and Georgian Bay
Our winters swing between thaw and freeze, sometimes in the same week. That cycle fills eavestroughs with ice, adds weight and works every loose seam a little more. Treed lots add needles and leaves that hold water and freeze solid. A system that limped through a mild winter can come down in a hard one.
How we handle it at Performance Exteriors
We inspect the fascia before we quote. If the wood behind the eavestrough is rotted, we replace it first.
We wrap the fascia in custom-bent aluminum so it can't rot again.
We install seamless aluminum eavestroughs, formed on site to fit your home. With no joints along the run, there are fewer places to split under load.
Our own crew does the work, and every job comes with a written workmanship warranty.
Projects start at $1,500.
Quick recap
Stay clear. Take photos. Check the board behind it. Then call someone who will fix the cause, not just the eavestrough.
Call or text 705-238-2441, or book your free estimate.